Configuration

You usually find the settings for the serial port under Services - Serial Utilities - Over IP.

There you need to define a configurationb as follows:

Parameter	Value
Device	rs232
Baudrate	Depending on the display board (usually 2400 for ALGE or 9600 for FDS MLED)
Data Bits	8
Stop Bits	1
Parity	None
Flow Control	None
Echo	off

Under General Tab set the following:

Mode	Client
Protocol	TCP
Destination Address	www.remoteredirect.com
Destination Port	Depending on your link, use number from Output side

Under Advanced Tab set the following:

Raw Mode	on
No leading zeros	off
Reconnect interval	30
Inactivity timeout	0
Serial timeout	empty
TCP Echo	off
Close connections	off
Connect on data	off
Keep alive time	0
Keep alive interval	0
Keep alive probes	0

More information on Teltonika TRB142 can be found here.