# Configuration

You usually find the settings for the serial port under *Services* - *Serial Utilities* - *Over IP.* 

There you need to define a configurationb as follows: 

| Parameter    | Value                                                                       |
| ------------ | --------------------------------------------------------------------------- |
| Device       | rs232                                                                       |
| Baudrate     | Depending on the display board (usually 2400 for ALGE or 9600 for FDS MLED) |
| Data Bits    | 8                                                                           |
| Stop Bits    | 1                                                                           |
| Parity       | None                                                                        |
| Flow Control | None                                                                        |
| Echo         | off                                                                         |

Under *General Tab* set the following:

|                     |                                                                                                                                                                                                                                                                                                                                   |
| ------------------- | --------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------- |
| Mode                | Client                                                                                                                                                                                                                                                                                                                            |
| Protocol            | TCP                                                                                                                                                                                                                                                                                                                               |
| Destination Address | [www.remoteredirect.com](http://www.remoteredirect.com)                                                                                                                                                                                                                                                                           |
| Destination Port    | <p>Depending on your link, use the port number from Output side<br><img src="https://3847703648-files.gitbook.io/~/files/v0/b/gitbook-x-prod.appspot.com/o/spaces%2FFbtMC8f1QdgENtfYkusr%2Fuploads%2FvMEa5kCAqXW9BUBn2elP%2Fimage.png?alt=media&#x26;token=2e8f0dbc-311b-48cb-8bdc-38f9080b5ac5" alt="" data-size="original"></p> |

Under *Advanced Tab* set the following:

<table><thead><tr><th width="454"></th><th></th></tr></thead><tbody><tr><td>Raw Mode</td><td>on</td></tr><tr><td>No leading zeros</td><td>off</td></tr><tr><td>Reconnect interval</td><td>30</td></tr><tr><td>Inactivity timeout</td><td>0</td></tr><tr><td>Serial timeout</td><td>empty</td></tr><tr><td>TCP Echo</td><td>off</td></tr><tr><td>Close connections</td><td>off</td></tr><tr><td>Connect on data</td><td>off</td></tr><tr><td>Keep alive time</td><td>0</td></tr><tr><td>Keep alive interval</td><td>0</td></tr><tr><td>Keep alive probes</td><td>0</td></tr></tbody></table>

## TRB142 Configuration Video

A short video on how to configure the TeltonikaTRB 142 can be found on the [dbnetsoft YouTube channel](https://www.youtube.com/channel/UCXYI2v8j8v2SRsVumkpd_1Q):&#x20;

{% embed url="<https://www.youtube.com/watch?t=51s&v=bvP9dw82ZvY>" %}